Verilog: Continuous & Procedural Assignments

Continuous Assignment

Continuous assignment is used to drive a value on to a net in dataflow modeling. The net can be a vector or scalar, indexed part select, constant bit or part select of a vector. Concatenation is also supported with scalar vector types.

Regular & Implicit Assignment

Regular continuous assignment means, the declaration of a net and its continuous assignments are done in two different statements. But in implicit assignment, continuous assignment can be done on a net when it is declared itself. In the below example, valid is declared as wire during the assignment. If signal name is used to the left of the continuous assignment, an implicit net declaration will be inferred. In the below code dout is not declared as net, but it is inferred during assignment.

Procedural Assignment

We have already seen that continuous assignment updates net, but procedural assignment update values of reg, real, integer or time variable. The constant part select, indexed part select and bit select are possible for vector reg.

There are two types of procedural assignments called blocking and non-blocking. Blocking assignment, as the name says, gets executed in the order statements are specified. The “=” is the symbol used for blocking assignment representation. Non-blocking assignment allows scheduling of assignments. It will not block the execution. The symbol “<=" is used for non-blocking assignment representation and mainly used for concurrent data transfers. Following example shows the differences in the simulation result by using blocking and non-blocking assignments.

3 comments on “Verilog: Continuous & Procedural Assignments

Leave a Reply to Adnan Nasir Cancel reply

Your email address will not be published. Required fields are marked *